Your Cart

Proxim ORiNOCO QB-9100 Wireless LAN Access Point

Proxim ORiNOCO QB-9100 Wireless LAN Access Point
Proxim ORiNOCO QB-9100 Wireless LAN Access Point

  • Radio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only)
  • Radio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end only) : Up to 150 Mbps
  • Radio #1 : Two N-type Connectors with built-in Surge Protection, Radio #2 (Remote end only) : Two N-type Connectors with built-in Surge Protection

  • Brand: PROXIM
  • Model: ORiNOCO QB-9100
  • Operating Temperature (-40 to 60°C)
  • Relative Humidity (100% relative humidity)
  • IP protection (IP67)
  • Marine
$0.00
Ex Tax: $0.00

The ORiNOCO QB-9100 products leverage Proxim’s extensive experience in both WLAN access points and wireless backhaul. The ORiNOCO QB-9100 products combine an ORiNOCO 2.4 GHz access point and a Tsunami Quickbridge® 5 GHz point-to-point backhaul radio into a single product. By using these products, end-users will be able to enjoy network and Internet access via the feature-rich ORiNOCO access point combined with a very high throughput (866 Mbps data rate) backhaul in a single unit. This combination of functionality in a single unit is designed to reduce the solution footprint (especially for city deployments where smaller is better), reduce initial capital expenditure costs, and reduce recurring site rental costs.

QB-9100 products can all be centrally managed with ProximVision™ Advanced, Proxim’s hybrid controller-network management solution. ProximVision Advanced gives network administrators tremendous flexibility and control of individual units in heterogeneous network environments, enabling rapid deployments by automating configuration processes, exhaustive software-based device configuration capabilities, and easy upgradability.


You can place an order for the Proxim ORiNOCO QB-9100 Wireless LAN Access Point online via one of our Middle East branches (Dubai/ Oman/Saudi Arabia) and get it delivered at a low cost at a specific time.

Access Point : Interfaces
Wireless ProtocolRadio #1: WORP®, Radio #2: 802.11b/g/n (Remote end only)
Access Point : Radio Specifications
FrequencyRadio #1 : 5.150 – 5.925 GHz (Subject to Country Regulations), Radio #2 (Remote end only) : 2.400 – 2.484 (Subject to Country Regulations)
ThroughputRadio #1 : Up to 633 Mbps @ 80 MHz, Radio #2 (Remote end only) : Up to 150 Mbps
OtherRadio #1 : Dynamic Channel Selection (DCS) based on interference detection, Dynamic Frequency Selection (DFS) based on radar signature , Automatic Transmit Power Control (ATPC) with EIRP limit support, Radio #2 (Remote end only) : Automatic Channel Selection (ACS)
Access Point : Antenna
Antenna TypeRadio #1 : Two N-type Connectors with built-in Surge Protection, Radio #2 (Remote end only) : Two N-type Connectors with built-in Surge Protection
Access Point : Management
RemoteTelnet and SSH, Web GUI and SSL, TFTP, SNMPv3
SNMPSNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
OtherSyslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
Access Point : Standards and Protocols
SynchronizationIEEE 1588v2 Ethernet Synchronization
Access Point : Security
EncryptionRadio #1 : AES 128, Radio #2 (Remote end only) : 802.11i/WPA2 and WPA Wireless Security with AES-128, TKIP or WEP
AuthenticationRadio #1 : Internal MAC Address Control List, Radius based Authentication, Radio #2 (Remote end only) : Enterprise/802.1x, Personal/ PSK (Pre Shared Key) or Open
Access Point : Network
ModesRadio #1 : Bridging (support LACP through external switches), Routing (RIP v2 and IP tunneling), Radio #2 (Remote end only) : Access Point
IP StackIPv4 and IPv6 simultaneously
Gateway FeaturesDHCP Server & relay, NAT with Std ALGs
VLAN802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
Access Point : Power Requirement
Power Input36 to 57 VDC via Ethernet port1 (PoE), 12 VDC via Access port, Power should not be provided simultaneously on both ports
Power Output48 to 57 VDC – 25 Watt max on Ethernet port2 (PoE – software controlled), 12 VDC on Access port
Power ConsumptionLocal end: 17 Watt typical, remote end 23 Watt typical
Access Point : Physical Characteristics
TemperatureOPERATING -40º to 60ºC (-40º to 140º Fahrenheit), STORAGE -50º to 70ºC (-58º to 158º Fahrenheit)
Humidity100% relative humidity
Dimensions Packaged9.84 x 8.66 x 2.83 in (250 x 220 x 72 mm)
IP RatingIP67
Weight (PACKAGED)9.92 lbs ( 4.5 kg) / 10.91 lbs (4.95 kg)

Write a review

Note: HTML is not translated!
Rating
Bad Good
Captcha